Author Topic: Barrel Wedge Clamp  (Read 2438 times)

  • Guest
Barrel Wedge Clamp
« on: January 12, 2012, 08:12:49 PM »

Barrel Wedge Clamp


 


[attachment=9508:Barrel Wedge Clamp-id=644.png]


Sparky,

After reading your last post I was curious about the wedge clamp. I looked at my barrel assembly, less than a 1/16 between the barrels. I made a drawing to determine the dimensions. There is just enough space for this to work. I did not size the relief in the barrel ring for the extractor tip as I have not determined it\'s dimensions. I will work on that next.


« Last Edit: December 24, 2014, 04:06:39 PM by Dave »

  • Guest
Barrel Wedge Clamp
« Reply #1 on: January 14, 2012, 01:43:01 PM »
I used the Wedge Clamp method on my barrels and it worked very well.

nitewatchman

  • Guest
Barrel Wedge Clamp
« Reply #2 on: January 14, 2012, 02:21:47 PM »
Nitewatchman,  are your screws as tiny as #3\'s ????   Wow, that is tiny.

  • Guest
Barrel Wedge Clamp
« Reply #3 on: January 14, 2012, 03:25:39 PM »
Niteman,
From reading your posts I gathered you were building an RG&G.

  • Guest
Barrel Wedge Clamp
« Reply #4 on: January 14, 2012, 03:34:10 PM »
Sorry,

Correct, I am building the RG gun but the screw are still small, 4-40 by 5/8\".