Author Topic: Silver Soldering the machined brass parts - Hint  (Read 2117 times)

  • Guest
Silver Soldering the machined brass parts - Hint
« on: February 12, 2010, 06:58:27 PM »
Did most of the silver soldering so far with MAPP gas and sometimes two MAPP gas torches to get the heat up high enough.

On my last trip to the hardware store I got one of those $50 Oxy-Mapp gas torch sets. It looked kinda \'bush league\' but it\'s \"the cat\'s meow\" for our RG-G\'s, a pinpoint flame and it gets super hot for some of the high mass brass parts.

The pinpoint flame cuts down tremendously on the thin brass warping from excess heat.

Wish I had started all the silver soldering with it.

  • Guest
Silver Soldering the machined brass parts - Hint
« Reply #1 on: March 16, 2010, 07:15:20 AM »
Did you silver solder the side rails on or use low temp. high force 44 solder?
Bill

  • Guest
Silver Soldering the machined brass parts - Hint
« Reply #2 on: March 27, 2010, 04:11:14 PM »
Conventional Silver Solder was used.

  • Guest
Silver Soldering the machined brass parts - Hint
« Reply #3 on: March 27, 2010, 07:16:45 PM »
So what was the silver content of the solder.  

Clutch