Author Topic: Elevating plate question. (Read 2154 times)

Swarfmonger · « **on:** August 07, 2020, 10:47:29 PM »

Hello all, I am past due needing to machine the elevation plate due in large part not being able to find any suitable 5/16â€ brass plate and was wondering if anyone has made one out of 1/4â€ steel? I have some on the rack and will use it if it will provide adequate stability. Also, if anyone happens to have a piece of 5/16â€ brass plate and needs a piece of brass breech casing tubing, top cover tubing or yoke tubing and would be interested in trading, let me know...

rayhawk · « **Reply #1 on:** August 08, 2020, 08:51:20 AM »

This may not help you if you are building the carriage, but I made mine out of 3/8 x 3/4 steel, with a 1 1/2\" diameter piece welded on for the handwheel/acme nut.

I also need a piece of the tubing for the magazine base, I need to remake mine at some point. Seems like I\'ll have to buy a big chunk to do so, I\'d be happy to buy a piece from you.

[attachment=11320:20200726_101521a.jpg]

butch · « **Reply #2 on:** August 10, 2020, 05:41:49 PM »

Hi, where can I buy the 3.250 OD X 3.00 ID tubing? Jack

Cutter · « **Reply #3 on:** August 11, 2020, 10:10:42 AM »

Hi, where can I buy the 3.250 OD X 3.00 ID tubing? Jack

The magazine base material can also be rolled.

Swarfmonger · « **Reply #4 on:** August 22, 2020, 11:36:14 AM »

Hi, where can I buy the 3.250 OD X 3.00 ID tubing? Jack

The piece I have I obtained on eBay and judging by the amount of tarnish on it it had been sitting on somebodyâ€™s rack for a very long time.

News:

Author Topic: Elevating plate question. (Read 2154 times)