I am selling a slightly used 1/32\" radius convex cutter that I used to cut the slots in the recoil pins. If you are wondering what slots I mean? In Drawing 48-20, Detail B (Recoil Pin), there is a 1/16\" wide slot to be milled into the recoil pins to serve as a pilot when you drill the hole for the firing pin through the bolt. The drawing shows a flat-bottom slot but I used this cutter which gave me a 1/16\" wide slot with a 1/32\" radiused bottom. The cutter worked very well and I was able to cut the slot much faster then I would have been able to with a 1/16\" endmill. The cutter has alot of life left in it plus it can be resharpened if you ever needed to. Since I don\'t plan to build another gat, it seemed a waste for me to hold onto this cutter when someone else could use it for their build. You can even re-sell it once your done.
I purchased this cutter from McMaster-Carr, Item:2800A71 for $54.35 + SH .
Asking $45.00 shipped anywhere within the lower 48 and Canada.
Paypal is best but MO also accepted.
