NEW HERE AND ALREADY QUESTIONS

HELLO   I just recieved plans and started building a few piecies. So far side rails,1 piece front bow complete,I have the carrier block,front and rear barrel plates and recoil plate off the lathe and ready for the mill. Alot more to this than i first thought. Heres a couple questions hopefully someone can help with,1 st where are the 4-40 holes located that hold the breech casing and box cam together?       2nd does any one have the cutter path just \"Y\" and \"X\" for the decagon on the carrier ?  also     the  box cam  I thought I could come down in \"Z\" to -1.438 and move towards center in\"y\"  move 1.175 in \"x\" and out in \"y\" lookig down from spindle    on turn table standing up with part 90 from spindle  \"X\" 0 breech end \"Y\" o CL of 2.875 dia.  mill 1 side    turn 180     mill other path   this is on a 3 axis cnc bridgeport

  thanks  markus

Here\'s the code for a .500 end mill

 

[attachment=9473:nc file-id=1018.zip]

thank you ill give it a try in the am

Markus,
I don\'t fully understand your strategy for milling the Cam.
So here\'s a 3D .IGS file, that can be cut with your 3 axis mill .