Barrel Wedge Clamp

Barrel Wedge Clamp

 

[attachment=9508:Barrel Wedge Clamp-id=644.png]


Sparky,

After reading your last post I was curious about the wedge clamp. I looked at my barrel assembly, less than a 1/16 between the barrels. I made a drawing to determine the dimensions. There is just enough space for this to work. I did not size the relief in the barrel ring for the extractor tip as I have not determined it\'s dimensions. I will work on that next.

I used the Wedge Clamp method on my barrels and it worked very well.

nitewatchman

Nitewatchman,  are your screws as tiny as #3\'s ?   Wow, that is tiny.

Niteman,
From reading your posts I gathered you were building an RG&G.

Sorry,

Correct, I am building the RG gun but the screw are still small, 4-40 by 5/8\".